can someone please advise me on the best starter motor for a pre rotator
thanks
Rex 0423100160
					thanks
Rex 0423100160
 (I use a soft start resistor circuit)
 (I use a soft start resistor circuit)
							
						 No electronics. Just a high wattage resister made from a few turns of nichrome wire. (Got the wire from the tip of an old 400 volt low tech gismo) Pass the motor current through the resistor for a few seconds and then use a universal solenoid to bridge out the resistor for max. speed. The solenoid can be used as a terminal block. Comes out neat. All I need now is one of you intellectuals to design a couple of blade tip rockets to finish off the job and push the blades up to 300rpm so I can get airborne by my front gate
 No electronics. Just a high wattage resister made from a few turns of nichrome wire. (Got the wire from the tip of an old 400 volt low tech gismo) Pass the motor current through the resistor for a few seconds and then use a universal solenoid to bridge out the resistor for max. speed. The solenoid can be used as a terminal block. Comes out neat. All I need now is one of you intellectuals to design a couple of blade tip rockets to finish off the job and push the blades up to 300rpm so I can get airborne by my front gate 
							
						 These little batteries even start my Mitsubishu 4 cly. diesel slasher engine.
 These little batteries even start my Mitsubishu 4 cly. diesel slasher engine.
							
						
Comment